Widescreen Gaming Forum

Put together a new machine, motherboard is dead. Put the old one back together and configured my PLP Eyefinity setup without a problem - same as always, but when i start Bezel Compensation, my sides get flipped back to landscape. Using the same connections and hardware as before, as well as drivers version (16.3.1). I tried with a new EF group a few times, as well as creating, restarting, and trying again. No change. Anyone else run into this?

Fury X GPU
32" on DP in landscape
2x 24" DVI-Active DP in portrait.

Now that I've typed that out, perhaps the order that the cables are arranged is the problem. I didn't consider making note of what cables where in which outputs on the GPU before taking it all apart... But I'll have to look at that later.

Fingered it out. Uninstalled all drivers and remnants, installed 15.12, set up screens, installed 16.3.2 over top. All is well. But I'm guessing trying to set it up again will break PLP once more.

Once more we see that crimson drivers are nowhere near ready ^^

Gesendet von meinem LENNY2 mit Tapatalk

_________________
We gonna send it to outa space!

Motherboard had a dead USB 3.0 and PCI-E x1 slot. Had to go through the same stupid process again. with a different replacement board and OS install. Arg.

Update: Problem persists with Crimson 16.5.2.1 Hotfix. grrrr.

i manage to contact amd support




let's hope!

update 1

update 2


he forget the link but i guess it's this one where he ask for system config
https://community.amd.com/message/2751150

new release 17.10.1

Fixed Issues
Bezel compensation in mixed mode Eyefinity cannot be applied.

i just download it and it finally work!