You can take the outer wings segments off, but you'll need to be careful not to strip out the bolt hole when reattaching. Also, don't lose the bolts.
I am going to be offering the 2x1 bar in the store as well, just need to get pics for it.
| Widescreen Gaming Forum http://www.wsgf.org/phpBB3/ |
|
| Looking to get a new stand/Setup http://www.wsgf.org/phpBB3/viewtopic.php?f=97&t=28974 |
Page 1 of 1 |
| Author: | DeathBlade [ 30 Apr 2015, 05:41 ] |
| Post subject: | Looking to get a new stand/Setup |
Hello WSGS people. I am looking to upgrade/get new stands for my setup and I am planing a 1x3 or 3x1 however you want to look at it however my current desk cannot fully hold a setup like that. I am looking to buy the the 3x1 stand from the stone here but I was wondering if anyone could answer a question. If I were to buy the 3x1 start can I leave one arm off and just use it as a 2x1 for a bit till I get a new desk or will that make it too unstable? Thanks! |
|
| Author: | skipclarke [ 30 Apr 2015, 13:12 ] |
| Post subject: | Re: Looking to get a new stand/Setup |
You can take the outer wings segments off, but you'll need to be careful not to strip out the bolt hole when reattaching. Also, don't lose the bolts. I am going to be offering the 2x1 bar in the store as well, just need to get pics for it.
|
|
| Author: | DeathBlade [ 30 Apr 2015, 13:20 ] |
| Post subject: | Re: Looking to get a new stand/Setup |
Hey, Thanks for getting back to me. Its nice to see the owners involved in these operations. It good to know I can take that off and have the stand still support it self. I will be doing a 3x1 but as mentioned current desk and GPU limits I am not able to do that. Thanks again! |
|
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|