Widescreen Gaming Forum

Here you go.

http://www.youtube.com/watch?v=7X2Bvb8-cqY

Ah yes I've seen that setup on Youtube before. Awesome awesome awesome!

Just thought I would post my experience:

Everything went fine with installing over 9.12 (not updated in a while), no issues what so ever with the install. I have 2 Ben Q side monitors and 1 Dell connected via DP and Bezel compensation works fine :)

I do seem to get the "display port disconnect bla bla" most of them time when I load up the bezel management but after I turn the monitor back on it works fine :)

You can also read a little bit here:

http://www.maxisdomain.co.uk/news/gaming-previews/164-preview-ati103

[quote]
Here you go.

http://www.youtube.com/watch?v=7X2Bvb8-cqY

Ah yes I've seen that setup on Youtube before. Awesome awesome awesome!


Thanks :cheers

[quote][quote] I have 3 identical 47" Vizio screens

:shock: :shock: :shock:

PICTURES PLEASE!!!!




Here you go.

http://www.youtube.com/watch?v=7X2Bvb8-cqY

Very cool! Very immersible...

_________________
Professional... well I'll figure that out.



"I sense something, a presence I've not felt since......."

Here you go.

http://www.youtube.com/watch?v=7X2Bvb8-cqY

Holy Jesus

_________________
System Core: | Intel Core i5-2500K + ASUS P8Z68-V + 16GB Corsair XMS3 DDR3 1333 MHz | Win7 x64 | MSI R7970 Lightning 3GB [1105/1400] |
Display: | 3 x Dell Ultrasharp 3007WFP-HC @ 7680x1600 | Dell u3011 |

So not sure if its new to 10.3 since I skipped 10.1 and 10.2 but the profile selection is working for me now. I can go from landscape to eyefinity to bezel managed eyefinity instantly with a saved profile rather than have to manually set it up or try to activate a profile 3+ times and hope for the best.

10.3 drivers are the landmark for ATI right now and the 5870. Good performance, working profiles, bezel compensation, and for me since I skipped 10.1 its the first set that gives me intermediate eyefinity resolutions. Though they should still add something above 600vert and below 1050vert so that we have one more intermediate resolution.

_________________
ViciousXUSMC on the Web - YouTube :: FaceBook :: Website

profile still doesn't work for me :(
using 10.3 cata preview

my last ati catalyst is 9.xx

Nice catch on eyefinity being part of profiles now.

Very helpful for switching between eyefinity and single monitor configuration.

Though I get the same effect simply from turning off my outside monitors, still, it is nice to see this implemented.

profile still doesn't work for me :(

Did you delete the old profile and save it again?

I am running a 5970 in eyefinity with three dell 2007fps with a dual boot of Vista64 on one hard drive and Windows 7 on another hard drive.

I installed the 10.3 preview drivers on my Windows 7 partition and it completely borked my computer. Everytime it boots in W7 all three of my monitors go black and I can hear the sounds of windows starting, opening etc, but I have no visual.

I am typing this with my vista boot, so what is the best way to remove the new drivers for my W7 partition because I cannot see anything on the black screens and cannot do it the traditional add/remove programs way? I can boot in safemode but it wont allow me to run the install/uninstall feature of the 10.3s in safe mode.

Thanks for any help!